Better_CornerPin | v1.0 |
Author
neil griffiths
neil griffiths
Requirements
4.8, 5.0, 5.1, 5.2, 6.0 or later
Linux
4.8, 5.0, 5.1, 5.2, 6.0 or later
Linux
Created on: 08/03/2011
Updated on: 08/03/2011
Downloads: 246
Updated on: 08/03/2011
Downloads: 246
Login or Register
hey i have made a corner pin node that some users may find useful. i made it because i got constantly annoyed with copying the values over in nuke's own cornerpin node. i feel that this is a much simpler tool.
it has two tabs a 'From' and 'To'. the from tab allows you to place your corner points around the area you want to effect then in the 'To' tab you can copy the values from the 'From' tab. there is also a check box so you can turn off the corner pin when ever you wan to adjust the points in the 'From' tab.
i hope people find this useful.
Comments (5)
Tom van Dop
said:
|
... Hey Neil, Is this working in 6.2v2? When i hit copy values, it just zeros out the to tabs. Any ideas? |
neil griffiths
said:
|
... hi saurav, i haven't tested this gizmo in on any other operating system other than linux but i would assume that it would work on all. |
neil griffiths
said:
|
... hi tom. i made the gizmo in nuke 6.0 but i just tried it in nuke 6.2v3 and it seems to work fine. not sure why that would be happening. sorry i cant be of more help. maybe try and upfdae to 6.2v3 and see if your getting the same issue. |
Write comment
You must be logged in to post a comment. Please register if you do not have an account yet.
