My first attempt at a gizmo. Simple gun laser sight setup that a colleague made. By default the colour is red. There is a check box to change the the colour to green, or change to the desired colour. The noise patterns are editable and viewable from the gizmo. To get started simply add a roto shape or matte about 4pixels in width into the LaserShape input and animate the shape to your shot's requirements. Any feedback in appreciated.
Draw a line between two points
Line drawing gizmo. Use it to draw lines on an input or use it as an input draw node. Subsample or don't if you are drawing vertical or horizontal lines.
This is a RotoPaint Gizmo, designed for one simple purpose.. removing and adding to a matte. (0, or 1).
2-color and 4-color gradient
This gizmo is created inspired by Flow box roto tool. Instead of creating roto and animating, one can draw a quick outline of a subject and it will create a solid roto for you. Very useful and timing saving tool. Feedback are highly appreciated
Same as the original grain tool but with curve control.
Offsets an rgb patch based on the alpha position. Used to remove unwanted areas of an image by copying another section of the same image over the problem area.
Applies an aspect mask over the image. The mask should properly adjust for image resolution and pixel aspect.